Wooster, Ohio – Seaman Corporation is proud to introduce the new FiberTite WRAPID Flash Molded Pipe Flashing. This revolutionary flashing boot dramatically reduces labor, enhances seal quality, and improves the appearance of any roof penetration. The injection molded WRAPID Flash pipe flashing is faster and easier to install than a traditional field fabricated pipe flashing and produces stronger, better-looking seals around rooftop conduits and pipes.
"Flashing any pipe or conduit, with a typical field wrap is labor intensive," says Jerry Beall, Product Manager of FiberTite Roofing Systems. "It takes special talent to pattern the base and collar, so that they tie together in a way that's water tight and meets the customer's expectations."
The FiberTite WRAPID Flash Molded Pipe Flashing offers better protection to any exterior penetration. Using a single piece of flashing, rather than two, the injected molding eliminates faulty fabricated seams. The entire installation process only takes the average roofer about 4 to 5 minutes to complete, which saves time and money.
The revolutionary design eliminates guesswork by providing integrated measurements and cut guidelines for quick and accurate trimming. The patent-pending WRAPID Flash's versatile design fits conduits and pipes from 3/4" to 3" in diameter.
To download PDF versions of the installation instruction and WRAPID Flash Advantages, visit www.fibertite.com/wrapid-flash.html
For information, contact Seaman Corporation at 330-262-1111 or toll-free 800-927-8578. Seaman Corporation, 1000 Venture Blvd., Wooster, OH 44691. [email protected]
To learn more about FiberTite visit fibertite.com or call 1-800-927-8578.